Marmitek MS8000 Manuale Utente Scaricare il pdf (Pagina 3)

8. External alarm contact:

This input allows you to connect any external alarm

device with a non-powered NO (Normally Open) or

NC (Normally Closed) contact. E.g. smoke alarms,

magnetic door/window contacts, flood and temper-

ature detectors, etc.

You may connect multiple devices in series to the

HomeGuard. This allows you to turn your

HomeGuard into a complete security system with

built-in telephone dialler.

To connect any external security device, use the

supplied cable with mini-plug or install an equiva-

lent jack plug on these devices.

3. WIRELESS KEY FOB REMOTE

CONTROL KR21 (OPTION)

ARM: Will put the HomeGuard into the armed position.

The alarm is instant or delayed. Delayed arming

allows you to leave the room within 30 seconds or

enter the room and switch off the alarm within 15

seconds after entering. The factory default is instant

arming (no delay). To change this setting please

refer to Delayed Arm (7).

DISARM: Switches off and resets the HomeGuard.

PANIC: If pressed simultaneously will cause an alarm

instantly.

Lights On/Lights Off: These buttons are not used

with HomeGuard.

Indicator flashes if remote transmits a command. If

indicator does not flash or lights up weakly, replace

the batteries.

The battery holder is located inside the remote.

The back of the remote can be easily opened using

your fingernails or a small screwdriver. Only use

3V lithium batteries model CR2016. Push the ARM key

for more than 3 seconds and release the button; the

indicator blinks. If batteries are replaced, you’ve to re-

SELECTING A SUITABLE LOCATION

The base station has a so-called passive infrared ele-

ment that detects any change in temperature with-

in its range. A certain amount of heat related to

human beings is detected for an alarm. However to

achieve the best performance of your HomeGuard,

note following installation recommendations before

installing:

a. It should be located at approx. 170-180cm

height on a fixed vertical surface e.g.

wall or cupboard

b. Choose a location where an intruder may pass

the monitored area at all time in an early stage

of intrusion.

c. Choose a location near to a wall outlet and tele-

phone socket.

HOMEGUARD MS8000 3

3 3

1 2 3 4 5 6 7 8

Commenti su questo manuale

Nessun commento

Marmitek MS8000 Manuale Utente Pagina 3

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Marmitek MS8000